单项选择题
Why is a Cisco UCS B250 server unable to support 16-GB DIMMs？（）
A. Dual-rank DIMMs are not supported.
B. 16-GB DIMMs are too slow.
C. The largest DIMM an Intel 55xx or 56xx CPU can address is 32 GB
D. The memory bus would be too long.
E. The blade would run too hot.
相关考题
-
单项选择题
Whatisthecauseoftheerror？（）
A. Missing control VLAN in VSM configuration
B. Missing packet VLAN in VSM configuration
C. VSM has no network connection to vCenter
D. VSM extension key is not installed on vCenter
E. vCenter extension key is not installed on VSM -
单项选择题
The network administrator is adding a new N1Kv to the vCenter， however， the administrator does not see the new switch under the networking tab of vCenter. The administrator issues the following command on the VSM to troubleshoot： VSM# show svs connections connection VC： ip address： 10.10.10.30 remote port： 80 protocol： vmware-vim https certificatE. default datacenter namE. DC1 DVS uuiD. 67 32 30 50 a6 d2 49 64-9e 1c 5f 49 e3 af 55 99 config status： Disabled operational status： Disconnected sync status： - version： - When attempting to fix the issue， the following error is seen： VSM-PRI-188# conf VSM-PRI-188（config）# svs connection VC VSM-PRI-188（config-svs-conn）# connect ERROR： [VMWARE-VIM] Extension key was not registered before its use What is the cause of the error？（）
A. Missing control VLAN in VSM configuration
B. Missing packet VLAN in VSM configuration
C. VSM has no network connection to vCenter
D. VSM extension key is not installed on vCenter
E. vCenter extension key is not installed on VSM -
单项选择题
Given the following configuration： port-profile type ethernet DATA-UPLINK vmware port-group switchport trunk allowed vlan 1-3967，4048-4093 channel-group auto mode on no shutdown state enabled port-profile type ethernet MGMT-UPLINK vmware port-group switchport trunk allowed vlan 10-12 channel-group auto mode on no shutdown state enabled VEMs are seen to be joining and then are lost from the Cisco VSM. How would you resolve this issue？（）
A. Remove second NIC from each port profile
B. Remove VEM from VSM （no vem X）， remove NICs， and reinsert
C. Ensure that VLANs on uplink profiles are not overlapping
D. Reinstall VEM
E. Issue the command "module vem X execute vemcmd set pinning module vsm 1"
