多项选择题
Refer to the exhibit. Both routers have been configured as VoIP gateways. They must also support traditional telephony devices to connect to analog telephones. Which two configuration changes would correctly support the voice requirements?（）
A.on each router， under the dial-peer voice 1 pots configuration， add the port fa0/0 command
B.on each router， under the dial-peer voice 1 pots configuration， add the port 1/0/0 command
C.on each router， configure dial-peer voice 1 as a voip connection and configure dial-peer voice 2 as a pots connection
D.under the dial-peer voice 1 pots configuration， change the destination pattern of 1111 to 2222 on the R1 router， and 2222 to 1111 on the R2 router
E.under the dial-peer voice 2 voip configuration， change the destination pattern of 1111 to 2222 on the R1 router， and 2222 to 1111 on the R2 router
F.under the dial-peer voice 2 voip configuration， change the destination target address of 10.2.2.2 to 10.1.1.1 on the R1 router， and the destination target address of 10.1.1.1 to 10.2.2.2 on the R2 router
相关考题
-
多项选择题
CiscoAutoQoStakestheinterfacetypeandbandwidthintoconsiderationwhenconfiguringwhichthreeQoSfeatures？（）
A.voice compression methodology
B.LLQ
C.CRTP
D.routing protocol
E.LFI
F.trust boundary -
单项选择题
Refertotheexhibit.Arouterhasa256kbpsFrameRelaycircuitconnectedtointerfaceserial0/0.AsalargeFTPpacketisbeingplacedintothehardwaretransmitqueueofinterfaceserial0/0，avoicepacketisplacedintothepriorityqueueofthatinterface.How，andinwhatorder，withepacketsbetransmitted？（）
A.the voice packet will be transmitted first， followed by the FTP packet in its entirety
B.the voice packet will be transmitted first， followed by the fragmented FTP packet
C.the FTP packet will be fragmented and the voice packet will be interleaved
D.the FTP packet will be transmitted first in its entirety， follow by the voice packet -
单项选择题
WhataccuratelydescribestheusageofaCiscoAutoQoScommand？（）
A.on Catalyst switches， the show auto discovery qos command is used to display the data collected during the Auto-Discovery phase
B.on Catalyst switches， the show auto qos command is used to display packet statistics of all classes that are configured for all service policies
C.on Cisco routers， the show mls qos maps command is used to verify the CoS-to-DSCP maps for egress packet queuing
D.on Cisco routers， the show auto qos command is used to display the AutoQoS interface templates， policy maps， class maps， and ACLs
